1, I solemnly promise to customers factory mold: Mold all warranty for three months. 2, I plant mold quality problems arise during the warranty period, will be timely, free repair or replacement; warranty period is counted from the customer after installation. Sliding mold is not in place, customers disassemble except damage caused by the screw. 1, I plant dies on 3-month warranty period, after a large number of practical verification of customers, I plant die life is two to three times the traditional mold, I plant mold resistant steel used in all high-quality, ensure the mold from the mold material aspects wear resistance. 3, I plant mold stratified process, each plate is full hardenability heat, so the mold cavity from the inside to the outside are the same hardness, a fundamental guarantee of the mold hardness and wear resistance. 1, due to the use of hierarchical processing and heat treatment process, I plant die life is 2-3 times that of traditional molds, so the price is equivalent to 30% -50% of the traditional mold. 2, I plant dies due to extensive use of advanced equipment, high-quality tool steel high proportion of material costs, labor costs accounted for the low. 3, all with line cutting mold cavity molding equipment, cavity pressure head in deep plate spacing of only 0.5mm gap, high precision burr-cement products, neat appearance. 4, I plant dies as a result of taking a layered process, the height of the cavity can be flexibly subtraction cement products according to the requirements in order to achieve the purpose of adjusting the height. 1, mold damage after normal use, the customer can send back the mold processing factory for repair. 2, mold damage discovered after the customer, to depot repair as soon as possible, in order to reduce the difficulty of mold maintenance. 3, mold after maintenance, quality standards can be fully restored to the new mold. 4, post-mold maintenance cost is relatively low, for a large number of customers to reduce the cost of production.